Skip to main content

Device Activation for Wireless-Only Deployments

Use this guide when activating a Mersive device in an environment where an Ethernet connection is unavailable. During setup, you can use Wireless Access Point (WAP) Mode to connect directly to the device, complete network configuration, and activate the device.

Before You Begin

Ensure you have:

  • A powered-on Mersive Mini or Pro device.

  • A wireless-enabled laptop, tablet, or mobile device.

  • Access to the wireless network the device will use after deployment.

  • Any required activation information for your Mersive deployment.

Note

WAP Mode is intended for setup and configuration when a wired Ethernet connection is not available.

What is WAP Mode?

WAP Mode allows a Mersive device to temporarily operate as a wireless access point. This enables administrators to connect directly to the device and perform initial setup, network configuration, and activation without using an Ethernet connection.

Use WAP Mode when:

  • Deploying devices in wireless-only environments.

  • Performing initial device activation before network access is available.

  • Recovering access to a device after network configuration changes.

  • Troubleshooting wireless connectivity issues.

Connecting to a Device Using WAP Mode
  1. Enable WAP Mode

    If the device is not already broadcasting its setup network, follow your device's setup procedure to enable WAP Mode. The device will create a temporary wireless network for configuration.

  2. Connect to the Device

    1. Open the Wi-Fi settings on your computer or mobile device.

    2. Locate the wireless network being broadcast by the Mersive device.

    3. Connect to the network.

    4. Wait until the connection is established.

  3. Access the Device Configuration Interface

    1. Open a supported web browser.

    2. Navigate to the device's local configuration page.

    3. Sign in if prompted.

The device setup and activation pages will become available.

Configuring Wireless Networking

After connecting through WAP Mode:

  1. Open the Network settings page.

  2. Select Wi-Fi as the network connection method.

  3. Enable Wi-Fi if it is not already enabled.

  4. Select the desired wireless network (SSID).

  5. Enter the network credentials.

  6. Save the configuration.

The device will attempt to connect to the selected wireless network.

Verify Connectivity

After the device joins the wireless network:

  • Confirm that the device receives a valid IP address.

  • Verify internet connectivity.

  • Ensure the device remains online after disconnecting from WAP Mode.

Activating the Device

Once network connectivity is established:

  1. Navigate to the Activation page.

  2. Enter the required activation information.

  3. Select Activate.

  4. Wait for the activation process to complete.

A successful activation message confirms that the device is registered and ready for use.